Aeroplane Lnstallation; Handle Adjustment; Shoulder Harness Position; Shoulder Harness Height Adjustment - Joie juva travel system Bedienungsanleitung

Aeroplane lnstallation

!
The Juva can only be installed using a lap belt if being
used in an aircraft without the base. Do not install in a
vehicle using a lap belt.
!
When being used in an aircraft, the infant child restraint
must only be installed rear facing on the seat.

Handle Adjustment

The handle of the infant child restraint can be adjusted to 3
positions (Fig. 5)
Position 1 Position for car, hand or stroller transportation.
Position 2 Rocking position.
Position 3 Baby chair position.
To adjust the handle, squeeze handle buttons on both sides to
release it (Fig. 6.1), and then rotate the handle until it clicks into
any of the 3 positions. (Fig. 6.2)

Shoulder Harness Position

Check that shoulder harnesses are set at the proper height.
Please choose the proper pair of shoulder harness slots
according to the child's height.
!
Shoulder harnesses must go into the harness slots nearest
to your baby's shoulders
shoulder line. (Fig. 8)
!
If the shoulder harnesses are not at proper height, the child
might be thrown from the infant child restraint when there
is an accident.
19
(Fig. 40)
(Fig. 7), but not above the
Shoulder Harness Height
Adjustment
1. Press the adjustment button at the front of the seat and pull
the shoulder harnesses to loosen them.
2. At the back of the seat, take the harness ends off the metal
junction plate. (Fig. 10)
3. Pull the harnesses through the slots in the seat
then insert them into the appropriate set of slots.
a.Thread the shoulder strap through shoulder harnesses.
b.Thread the shoulder harness anchor through the shoulder
harness slot.
c.Thread the shoulder strap through the shoulder harness slot.
4. Reassemble the harness ends onto the junction plate.
!
Thread the shoulder strap through the shoulder harness
anchor.(Fig. 12.1)
!
The shoulder harnesses must be placed in back of the
two iron tubes.
! During adjustment, make sure the shoulder harnesses
are not twisted.
!
Use extreme care in threading the shoulder harnesses
according to the figure. If the shoulder harnesses are not
secure, they will not protect your baby properly.

Securing Child

Restraint
Note
1. Insert is for infant's protection. Infant weighing under
10kg must use the insert A or B.
2. If the accessory is insert A, please assemble the foam
before using the insert.
3. After child is placed into the seat, check whether the
shoulder harnesses are at proper height.
(Fig. 9)
(Fig. 11.1), and
(Fig. 11.2)
(Fig. 12)
in the Infant Child
(Fig. 13)
(Fig. 7)
20