Specifications - Makita HP1620 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Lamp
3-1. Reversing switch
4-1. Action mode changing lever

SPECIFICATIONS

Capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Downloaded from www.Manualslib.com
Explanation of general view
5-1. Side grip
6-1. Chuck key
7-1. Sleeve
7-2. Ring
8-1. Depth gauge
Model
Concrete
Steel
Wood
-1
No load speed (min )
Blows per minute
Overall length
Net weight
Safety class
A-weighted noise level
) : 95 dB(A)
pA
) : 106 dB(A)
WA
Wear ear protection
total value (tri-axial vector
2
) : 22.0 m/s
h,ID
2
2
) : 3.0 m/s
h,D
2
manuals search engine
HP1620/HP1620F/HP1621/HP1621F
ENE039-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF002-2
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
determined
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG900-1
EC Declaration of Conformity
We Makita
sum)
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Hammer Drill
Model No./ Type: HP1620, HP1620F, HP1621,
HP1621F
are of series production and
Conforms to the following European Directives:
2006/42/EC
3
8-2. Side grip
8-3. Grip base
9-1. Blow-out bulb
16 mm
13 mm
30 mm
0 - 2,800
0 - 44,800
303 mm
2.0 kg
/II
Corporation as the responsible
ENG901-1
ENH101-16