Gb User Instructions; Positioning The Antenna - MELICONI AT52 Gebrauchsanleitung

The AT52 amplifi ed indoor antenna receives standard and HD digital terrestrial TV signals and
DAB radio signals in the VHF (band III) and UHF bands.
The antenna may be connected to a television set or a Digital terrestrial decoder.
WARNINGS
- Keep away from water: the antenna must not be exposed to drips or sprays of water. Do not
- The device must not be connected to any other power supply than the one it is supplied with.
- The power supply unit must be easily accessible to enable the electric separation of the device
- Disconnect the devices from the electrical mains supply before connecting them together.
- Do not tamper with, or attempt to repair the device – danger of electric shock.
- In the event of a fault with the power supply unit, disconnect it from the electrical mains socket
Secure the metal support (supplied with the kit) to the body of the antenna by inserting the ends
into the corresponding holes on the rear of the antenna (Figure 1).
For best reception, position the antenna near a window or an external wall, away from metallic
objects, electrical equipment and walls in reinforced concrete, which may affect its performance.
- Connect the Meliconi antenna cable to the socket on the rear of the television set or digital
- Use the AC/DC power supply included in the kit to power up the antenna: insert the cable in
- Switch the antenna in using the switch (A), which is built-in in the power unit jack. For the best
- Check that the antenna has been switched on correctly: the red LED on the front of the
- Switch the television set (or the digital terrestrial decoder) on and select the desired channel.
If necessary, perform the TV tuning or the decoder tuning referring to the relevant manual.
Downloaded from www.Manualslib.com
"AT52" AMPLIFIED INDOOR ANTENNA
FOR DIGITAL TERRESTRIAL SIGNALS
USER'S INSTRUCTIONS
Thank you for choosing MELICONI.
use in a damp environment or outdoor.
from the electrical mains supply.
immediately.
A

Positioning the antenna

B
terrestrial decoder (fi gure 2). If the decoder is fi tted with an F-female type antenna socket,
use an F-male plug to IEC-female socket adapter (not included).
the antenna power supply input and connect the power supply unit to the mains power supply
(fi gure 3). Alternatively, in the case of certain decoders the power supply can be supplied
directly via the antenna cable (see the TV or the decoder manual).
gain, turn the amplifi cation control device (B) on the rear of the antenna counter-clockwise.
antenna must be illuminated.
manuals search engine
Installation
GB
5