mspa Lite LS04-NA Handbuch Seite 12

moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for outdoor installation
weight of the filled spa and maximum occupants.
the spa floor.
Always keep the manometer on yellow section when using the spa at a temperature higher than 20°C
Do not install or use the spa outdoor at a temperature lower than 4°C (39°F). Do not use the spa when the
water inside circulation system, pump, or pipework is frozen. Put a Heat Preservation Mat (available in
square models) in between the spa bottom and the ground to prevent heat loss from the bottom of the spa
and to provide better heat retention.
PRCD Testing
Risk of electric shock: This product is provided with a PRCD located at the end of the power cord. The
PRCD must be tested before each use. Do not use the spa if the PRCD does not function properly.
Disconnect the power cord until the fault has been identified and corrected. Contact a licensed electrician to
correct the fault. There are no serviceable parts inside the PRCD. Opening the PRCD will void the warranty.
1. Plug the machine into the mains.
2. Press the RESET button on the PRCD. The indicator turns red.
3. Press the TEST button on the PRCD. The red color shown on the indicator should disappear. Otherwise the
PRCD is faulty. Do not use the spa if the spa is faulty. Contact a qualified electrician to correct the fault.
4. Press the RESET button on the PRCD again. The indicator should turn red. If yes, the spa is ready for use.
1.
√
Spa Control Unit Connected External Equipotential Bonding Conductors
A qualified electrician shall wire the spa control unit to the household equipotential terminal using a minimum
1.5mm² solid copper conductor.
PRCD doesn't
work on faulty
sockets or
plug boards.
! WARNING
2.
RESET
RESET
TEST
Indicator
12
3.
RESET
TEST
TEST