Functional Description; Intended Use; Product Features - Bosch GST 14,4 V Professional Originalbetriebsanleitung

Do not brake the saw blade to a stop by ap-
plying side pressure after switching off. The
saw blade can be damaged, break or cause
kickback.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Hold power tool by the insulated gripping
surfaces, when performing an operation
where the cutting tool may run into hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Avoid unintentional switching on. Ensure
the On/Off switch is in the off position be-
fore inserting battery pack. Carrying the
power tool with your finger on the On/Off
switch or inserting the battery pack into
power tools that have the switch on invites
accidents.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e.g.,
also against continuous sun irradiation
and fire. There is danger of explosion.
Bosch Power Tools
Downloaded from www.Manualslib.com manuals search engine

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or
serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Safety switch for On/Off switching
2 On/Off switch
3 Battery unlocking button
4 Battery*
5 Base plate
6 Switch for sawdust blowing device
7 Adjusting lever for orbital action
8 SDS clamping lever for saw blade release
9 Stroke rod
10 Guide roller
11 Contact protector
12 Saw blade*
13 Splinter guard*
14 Sliding shoe
15 Screw
16 Lead for the parallel guide
17 Locking screw for parallel guide*
18 Parallel guide with circle cutter*
19 Centring tip of the parallel guide*
*The accessories illustrated or described are not in-
cluded as standard delivery.
English | 19
1 609 929 N47 | (29.1.08)