Cleaning And Care - KKT KOLBE DELTA Bedienungsanleitung

English

7. Cleaning and care

Prior to any maintenance or cleaning work,
isolate the hood from the electrical supply by:
pulling out the appliance connector plug
or
tripping the house installation circuit breaker
or
fully unscrew the screw ty pe fuse from the house
installation
The extractor hood is not to be cleaned with a
steam cleaner .
Do not use cleaning agents containing
alcohol to clean appliances with a matt black
finish. These can lead to discolouring.
Non-compliance with the maintenance and
cleaning instructions can result in a fire hazard
due to grease deposits.
The grease filters on your appliance are to be
cleaned or replaced at regular intervals.
Filters saturated with grease can quickly catch
fire and also distribute unpleasant odours.
Grease filters obstructed by dirt particles
seriously impair the appliance function.
When cleaning the area of the control elements,
take great care to prevent water entering the
electronics.
Special information for appliances with
a stainless steel casing
A commercially available non-abrasive stainless
steel cleaning agent should be used for cleaning
stainless steel surfaces.
Treatment with a stainless steel preservative is
recommended to prevent surfaces becoming quickly
re-soiled. Apply the agent all over and economically
using a soft cloth.
Never use stainless steel cleaning agents in
the vicinity of the control elements.
When cleaning metal grease filters take care
not to damage the mesh. Frequent cleaning or the
use of aggressive cleanin g agents can cause colour
changes to the metal surface. These do not affect
the filter function and are not grounds for
complaint .
fi90520ATL
Operating instructions / users manual Cooker Hoods
7.1 Changing the grease filter
Grease filters must occasionally be changed. The
following rules apply:
Change paper grease filters
Change paper grease filters with alarm
two months or when the colour of the surface
becomes visible through the mesh openings. This
filter is coloured on one side; after fitting, this
colouring must not be visible through the mesh
openings.
Foam grease filters
month in warm soapy water for 1 to 2 hours. Do
not wring out; repeat where required and replace
the filter by a new item after a maximum of 5-6
washes.
Metal grease filters
when they are over-saturated but washed once a
month by hand or in a dishwasher (60°) (please do
not use a corrosive rinsing agent). Allow the filter
to dry thoroughly and carefully replace it in the
extractor hood.
Avoid using alkaline dishwasher cleaning
agents (ph value over 7).
Carbon filters
a) Traditional carbon filters (normally round in
shape) can be neither washer nor regenerated.
In normal use and depending on their size,
replace every 4 to 6 months. Comply with the
relevant instructions on the package.
b) Washable and regeneratable carbon filters
(normally square in shape)
once a month in a dishwasher, using a standard
rinsing agent and with the intensive rinsing
program (at the highest temperature).
Washable and regeneratable carbon filters
absorb kitchen odours for a maximum of 3 years
when cleaned monthly. The filter should then be
replaced by a new item.
Washable and regeneratable carbon filters
should be washed separately to avoid food residue
deposits which can later cause unpleasant odours.
After washing, the washable and regeneratable
carbon filter must be reactivated. This is carried out
by drying the cleaned filter in an oven for 10
minutes at 100°C.
Read the package to see whether your carbon filter
is washable and regeneratable.
If the package carries no information, then it
contains a traditional, non-washable carbon filter.
5
GB
monthly
must be soaked once a
do not have to be replaced
are to be washed
every