Dc/Ac Voltage Measurement - SATA 03055 Bedienungsanleitung

03055 /03075
4. Connect the probes to the two ends of the power or circuit to be measured.
5. Take the readings indicated on the screen.
Note
1. When the probe has not been connected to the power or circuit to be measured, an instable reading may be indicated by the meter. This
is normal and does not affect measurement.
2. "OL" appearing on the screen indicates overrange. In that case, a larger range or a higher position shall be selected for measurement.
3. To avoid electric shock or damage to the meter, never apply a voltage greater than 600 V to the input end.

DC/AC voltage measurement

1. Connect the black probe to "COM" jack. If the absolute current to be measured is less than 400mA, connect the red probe to"
the absolute current to be measured is equal to or greater than 400mA (within 10A), connect the red probe to "A" jack.
2. If the red probe is connected to "A" jack, set the function switch to "A" position. If the red probe is connected to "
function switch to " " or "
3. When DC is to be measured, press and hold "SELECT" button until "
When AC is to be measured, press and hold "SELECT" button until "
4. Switch off the power of the circuit to be measured, connect the probes in series to the circuit to be measured, and then switch on the power of
" position.
" symbol appears on the screen.
" symbol appears on the screen.
EN DE RU KO PT JA
" jack. If
" jack, set the
- 03 -
45
ES