SATA 03055 Bedienungsanleitung Seite 44

03055 /03075
Measuring DC voltage
1. Connect the black probe to "COM" jack and the red probe to"
2. Set the function switch to "
3. If the function switch is set to "
4. Connect the probes to the two ends of the power or circuit to be measured.
5. Take the readings indicated on the screen. During DC voltage measurement, the polarity of connecting end of the red probe will be indicated.
Note
1. When the probe has not been connected to the power or circuit to be measured, an instable reading may be indicated by the meter. This
is normal and does not affect measurement.
2. "OL" appearing on the screen indicates overrange. In that case, a larger range or a higher position shall be selected for measurement.
3. To avoid electric shock or damage to the meter, never apply a voltage greater than 600 V to the input end.
Measuring AC voltage
1. Connect the black probe to "COM" jack and the red probe to "
2. Set the function switch to "
3. If the function switch is set to "
- 03 -
44
"or " "position.
" position, press and hold "SELECT" button until "
" or " "position.
" position, press and hold "SELECT" button until "
"jack.
" symbol appears on the screen.
"jack.
" symbol appears on the screen.
EN DE RU KO PT JA ES