Honeywell F90C Gebrauchsanleitung Seite 2

HOW DO I CLEAN THE ELECTROSTATIC CELL AND PREFILTER?
{It is essential to wash the cell and prefilter regularly to maintain efficiency}
CAUTION!
•
RESPECT YOUR ENVIRONMENT! ONLY USE DETERGENT LOW IN PHOSPHATES!
•
DO NOT USE ACID BASED DETERGENTS AS THESE WILL CORRODE THE CELL.
•
DO NOT USE ADDITIVE INTENDED TO GIVE SPARKLE TO GLASSWARE IN DOMESTIC
DISHWASHERS. THIS WILL REDUCE THE EFFICIENCY OF THE CELL.
Downloaded from www.Manualslib.com
What should I do if the handset doesn't work?
To switch the air cleaner on use the switch
access cover
access cover and remove to reveal switch. Replace
cover again and the air cleaner will run at selected speed.
Remember to switch back to REMOTE position
before trying to use the handset again.
Can I control the direction of the air leaving the air
cleaner?
Adjust the direction of the clean air using the directional
louvres
1. Isolate the device from the mains supply.
2. Remove the access cover
3. Slide out the cell
NOTE: CEILING MOUNTED MODELS
To remove cell and prefilter for washing, carefully release
cell retention clip
prefilter with your other hand to prevent them from falling.
WASHING THE CELL
Dilute the detergent according to manufacturers instruc-
tions and soak the cell in the solution agitating frequently
until free from dirt.
Be careful!
Wear rubber gloves when washing the cell taking care to
avoid damaging the cell and injuring yourself.
manuals search engine
. Press firmly on both sides of the
.
both sides.
and prefilter
while supporting the cell and
under the
by pressing firmly on
.
3