Initial Operation; Overload Protection - Würth STP 28-A Originalbetriebsanleitung

STP 28-A.book Seite 16 Mittwoch, 6. März 2019 8:50 08
ter approx. 4 seconds the battery charge display au-
tomatically turns off.
When the first display element begins to flash (0 –
10 %) the battery is almost empty and must be
recharged.
Mounting and Adjustments
Replacing/Inserting the
Saw Blade (see figure
Before any work on the machine, remove the
battery.
When inserting and changing the saw blade 16
we recommend wearing protective gloves.
Open the saw blade release/lock 14 ( ).
Insert the saw blade (teeth facing in the direction of
the cut) into the saw blade holder until it engages.
When inserting the saw blade, make sure that the
back of the saw blade engages in the groove of the
guide roller 11.
To lock the saw blade, close the saw blade re-
lease/lock ( )).
Adjusting the Cutting Angle
(see figure / )
B C
Release lever 6 and slide the base plate 10 toward
the front in the direction of the saw blade.
The base plate can be swivelled either to the left or
right by 45° max. Adjust the cutting angle with
scale 8. The base plate can be engaged at 0° and
45°.
Push the base plate 10 toward the rear.
To lock the base plate 10, tilt the lever for adjustment
of the base plate 6 back again.
If the base plate 10 is not seated tightly anymore
after clamping the lever 6, readjust the adjustment
screws ( 20/ 21).
Sliding Shoe for Base Plate
When sawing materials that are easily scratched,
the sliding shoe 7 avoids scratching up sensitive sur-
faces.
For mounting, insert the sliding shoe at the front of
the foot plate, lift at the rear and latch in.
Splinter Guard (see figure
The splinter guard 18 prevents fraying of the surface
being sawn. The splinter guard can be inserted in
the base plate or in the sliding shoe.
16
)
A
)
D
Insert the splinter guard in the base plate 10 or in the
sliding shoe 7, and pay attention that the edges en-
gage into the guides. Afterwards, push the splinter
guard toward the rear to the stop.
The splinter guard is removed in reverse order.
The splinter guard cannot be used for certain saw
blade types (e. g., saw blades with set teeth).

Initial Operation

Inserting the Battery (see figure
Slide the charged battery 4 in into the handle until it
can be felt to latch.
Switching On and Off (see Figure
Switching on: Push the On/Off switch 1 forward.
Switching off: Release the On/Off switch 1.
Locking on: Push the On/Off switch 1 forward
and press it down at the front until it
engages.
Switching off: Press the rear tip of the On/Off
switch 1 down.
The switch snaps back to the Off posi-
tion.
Restarting Protection
When the battery is inserted while the On/off switch
is pressed, the machine will not restart again for
safety reasons!
To restart the machine, switch Off and then On
again.

Overload Protection

When the motor is subject to overload, the overload
protection is actuated.
To continue working, switch the machine Off and
then On again.
Stroke Rate Settings
With the illuminated button for stroke rate adjust-
ment 2, it is possible to switch between two stroke
rates.
1. gear: Low stroke rate, button is lit
2. gear: High stroke rate, button is not lit
The last setting will remain stored.
Contact Protector
The contact protector 13 attached to the housing
prevents unintentional contact with the saw blade
while working and should not be removed.
)
E
)
F