Before Initial Operation - probst VPH-150-GREENLINE Betriebsanleitung

5. BeFore iNitiAl operAtioN

– Before each initial operation, check the charger as well as its leads for
damages.
– Do not start using the device under any circumstances if the protecting
insulation of the mains or charger leads is damaged (squashed, ripped down
or ripped off).
– Never work with the charger in spaces or unfavourable environment conditions
that contain or may contain inflammable gases, smoke or dust.
– Never cover ventilation slots or containers.
– Do not place the device near hot air sources such as radiators or similar. Do
not expose the device to sunlight, strong dust formation, mechanic vibrations
or thrusts. Do not use the device near or on easily inflammable materials. If
necessary, use an appropriate non-inflammable basis (e.g. a big, thick wall
tile or flagstone).
– Do not place or guide the mains or charger leads near inflammable
materials.
– Ensure that no inflammable objects (wood, cloths, cleaning rags or similar) are
placed near the device. The mains or charger leads must not be modified,
extended or shortened. In addition, the leads must neither be bent, squashed
nor be guided through square-edged parts.
– Current conducting cables or leads that are connected with the device, must
be checked for insulation faults such as points of rupture, squashing or bending
before and after using the device. In case of fault detection (damage) of the
cable, the device must be disposed of immediately.
– Only start using the device outside of the vehicle. Ensure that a secure and
stable connection is established when connecting the battery charging
clamps.
– Never deep charge the batteries to avoid damage of the batteries.
operating note
The device heats up when operating. Make sure there is sufficient ventilation.
The case must not be covered. Never charge lead batteries in a closed
container. When charging sufficient ventilation must be ensured and open fire
must be avoided.
Automatic Charger AL800
| 19