Operation Messages; Error Messages - Worx LANDROID L1000 Benutzerhandbuch

OPERATION MESSAGES

MESSAGE
Cutting grass
Raining
Going home
Charging
No working time scheduled
Not working today
Work done today
Zone searching
Charge complete
Emergency charge

ERROR MESSAGES

Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in
doubt, please visit our website where you will find useful videos and further support.
MESSAGE CAUSE
Battery pack cover is open
Outside working area! Landroid cannot find the
Press START to reset. boundary wire signal.
WRONG PIN! Please PIN code is wrong.
retry.
Blade motor fault! Blade disc is blocked by an
Press START to reset. object, e.g. a branch.
Blade is over-loaded by
thick dense grass.
LANDROID ACTION
Cutting grass according to the mowing schedule.
The rain sensor detects water. Landroid will return to the charging station and
stay there for the time you have programmed it to do so. When dry, Landroid will
automatically begin the rain delay countdown and then return to mow. If you want
Landroid to mow before this, simply turn it off then on again, but only when the rain
sensor is dry, or you can remove the rain delay completely by setting the rain delay
time to zero.
Needs to recharge—during the journey to the base, the cutting blade is stopped in
order to save energy.
'Charging' and charge percentage are displayed.
Stand-by, needs to be programmed as desired.
Stand-by, will start according to mowing schedule.
According to the setting of 'Customize work zone', Landroid is searching a certain
area to mow.
Landroid has completed its charging.
Landroid is charging in a powered-off state.
ACTION
Close the battery pack cover
1. If Landroid is actually outside of its working area: turn power off, take
Landroid inside the working area, turn the power on and press start.
2. If Landroid is inside its working area check if the LED on the charging
pile is solid green. If red, check if the boundary wire is properly connected
to the charging pile and that the pile is connected to a suitable power
supply. If they are properly connected, the boundary wire terminals are
clamped incorrectly and must be reversed.
Input the correct PIN or re-set your PIN.
Turn power off.
Turn Landroid upside down and check if there's anything preventing the
blade disc from rotating and remove any obstruction.
Turn Landroid upright.
Turn power on. Press start
Turn power off.
Take Landroid to an area with short grass or adjust the cutting height to a
higher setting.
Turn power on. Press start.
EN
15