The Timer Function - Blomberg mkl 5460 x Gebrauchsanleitung

If the element to be controlled is a triple-circuit radiant hotplate, the following applies:
•
Pressing the multiple-circuit button for the first time switches off the outermost circuit and the
indicator light at the top of the display.
•
Pressing the multiple-circuit button a second time switches off the median circuit and the
indicator light at the bottom of the display.
•
Pressing this button a third time, switches on the median circuit again. Further pressing adds
the third circuit and its related indicator light.
The following activity is indicated by a buzzer during use:
•
A short sound for normal button pressing.
The timer function is the following:
•
The Timer is autonomous for 1.99 min.: there is a sound signal when this time is up. This
function is only available when the hob is not in use.
•
If the touch control is off, the autonomous timer can be used by pressing the timer button.
The display indicates "00". By pressing the start button, the touch control returns to the
stand-by mode and the timer is switched off.
•
The values can be altered (0-99 min.) increasing by one minute using any PLUS button from
0 to 99 and the MINUS button from 99 to 0.
•
Continuously pressing the PLUS or MINUS buttons will greatly increase the variation speed
until a maximum value, without sound signals.
•
If the PLUS (or MINUS) button is released, the increase (decrease) speed will start again
from the initial value.
Triple circuit operation:
The Acoustic signal (buzzer)

The Timer function

The Autonomous Timer
9