Controller - Pfannenberg DTI Betriebsanleitung

ENG
3.4.2

Controller

The controllers are control units for setting refrigeration functions and operating data. They allow readouts of system messages
and diagnostic data.
The controllers have a service interface at which different configurations are possible.
They also have a connection for collective fault signals.
Fig. 3: Operating display Standard-Controller (SC)
Cooling units with a Standard-Controller (SC) have an indicator unit with a green LED-light (1).
The indicator unit is on the unit cover. Steady lighting of the green LED-light (1) when mains voltage is applied indicates fault-
free operating mode.
The LED light (1) starts flashing in the event of an operating fault or malfunction. For details of error messages, see "Error
messages", Page 53.
3.4.2.1 DIP-switch
Position of the controller
Fig. 4: DIP-switch on the SC-Controller
1 SC-Controller
The DIP-switch on the controller facilitates the setting of the target and limit values for temperatures.
• Selection of the temperature unit (°C / °F)
• Selection of the temperature target and limit values.
For factory setting and setting possibilities, see "Setting the DIP-switch", Page 34.
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 400 / 460 V, 3~ | 086100009d
DIP-switch
2 DIP-switch
G00002
G00003
14/60