Installation; Preparing The Installation - CONSTRUCTA CD646850 Gebrauchs- Und Montageanleitung

Installation

I n s t a l l a t i o n

Preparing the installation

Caution!
Ensure that there are no electrical wires, gas pipes or water
pipes in the area where holes are to be drilled.
Mark a vertical centre line on the wall from the ceiling to the
1.
lower edge of the extractor hood.
Use the enclosed template to mark the positions for the
2.
screws and the outline of the attachment area.
Drill five 8 mm diameter holes to a depth of 80 mm for
3.
fastening the appliance and press in the wall plugs flush with
the wall.
Installation
Screw on the fixing bracket for the flue duct. ¨
1.
Screw on brackets for the extractor hood hand-tight. Do not
2.
firmly tighten the screws. ©
Screw in the threaded bolt, leaving it protruding out of the
3.
wall by 5–9 mm. ª
27