Switching On And Off; Selecting The Correct Rotational Speed And Sanding Belt - Parkside PBS 600 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Connection:
j
Push the adapter for external vacuum extraction
into the adapter port
12
use the reducer piece
into the adapter for external vacuum extraction
j
Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
if used.
Removal:
j
Pull off the dust extraction device hose.
j
Pull off the adapter for external vacuum extrac-
tion
12
Operation
Q

Switching on and off

Q
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
j
Press the ON / OFF switch
To switch off intermittent operation mode:
j
Release the ON / OFF switch
To switch on continuous operation mode:
j
Press the ON / OFF switch
pressed, then press the locking knob
To switch off continuous operation mode:
j
Press and then release the ON / OFF switch
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
Downloaded from www.Manualslib.com
. If it is necessary to
9
, push the reducer piece
13
with the reducer piece
12
(with the reducer piece
13
3
.
3
.
, and keep it
3
even whilst the sander is running.
1
manuals search engine
Material / type of
work
Coarse finish
(Grit grade)
.
12
Fine finish (Grit grade) 240
Preselected rotation
speed
,
13
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 180
, if used).
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) ––
Preselected rotation
4
.
speed
Material / type of
3
.
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 320
Preselected rotation
speed
Preparing for use / Operation
Softwood
60
high (5-6)
Hardwood
60
high (5-6)
Chipboard
60
high (5-6)
Removing paint /
varnish
60
high (5-6)
Sanding varnish
150
low (1-2)
GB/IE 11