Carson Reflex Wheel Ultimate Touch Betriebsanleitung Seite 63

Telemetry module FS-SVT01
Battery voltage recognition module
Procedure:
1. Connect one end of the 3-pin connecting cable
to the "Out" terminal of the telemetry module
and the other end to the "IN" terminal of the
receiver, or to the "IN" terminal of one of the
sensors already connected.
2. Switch on the transmitter and the model (receiver).
"Ext.voltage4: 12.40V" will now be displayed on
the main screen, which means that the installation
was successful.
Warning!!!
The polarity of the red and black connectors must
never be reversed. Doing so would damage the
electronic components.
Advice
The sensor modules must always be connected to
the "IN" terminal. Do not connect the sensors to the
"OUT" terminal, as otherwise incorrect values are
transmitted to the receiver and the receiver and the
telemetry modules can be damaged.
Downloaded from www.Manualslib.com
+
CARSON Reflex Wheel Ultimate Touch 500500516
manuals search engine
x
3. Next, connect the red and black contact connector
to the balancer terminal of your LiPo driving
battery. The red connector is for the positive
terminal and the black for the negative terminal
(outermost black cable on the balancer connector,
see diagram).
Example: "Ext.voltage4: 12.4V" is displayed on the
transmitter screen. This is the current voltage value
of your LiPo battery which is connected to the
sensor module.
GB
63