Mounting The Charging Station - Eaton xChargeIn Bedienungsanleitung

xChargeIn
6.4

Mounting the charging station

The charging station must be prepared for this before mounting. To do this,
proceed as follows:
1) Unscrew the two screws on the bottom side of the housing cover.
2) Lift the housing cover at bottom max. 1 cm
3) Loosen the four screws of the connection panel cover and remove the
4) Loosen the two screws of the terminal cover and remove the terminal
5) Place the charging station on a stable surface.
6) Using a hammer and flat-head screwdriver, gently knock out the re-
Installation manual V1.05
© EATON
connection panel cover upwards.
cover upwards.
quired cable insertion openings
− Surface-mounting cable insertion: Cable insertion openings on the top
side
− Flush-mounting cable insertion: Cable insertion openings on the back
side
Mounting and installation instructions
1 and then push upwards 2.
279