Troubleshooting - ZANKER KOU20612 Benutzerinformation

7
2
1
7
First lift carefully and
then remove the glass
panel.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite
sequence.
The screen-printing zone must face the inner side of the
door. Make sure that after the installation the surface of
the glass panel frame on the screen-printing zones is
not rough when you touch it.
Make sure that you install the internal glass panel in the
seats correctly.

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
The cooking zones do not operate.
The oven does not heat up.
The oven does not heat up.
14
Replacing the lamp
Put a cloth on the bottom of the interior of the appliance.
It prevents damage to the lamp glass cover and the
cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or deactivate
the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cooking surface.
The oven is deactivated.
The fuse is released.
Warning! Danger of electrocution!
Disconnect the fuse before you replace
the lamp.
The lamp and the lamp glass cover can
be hot.
Remedy
Activate the oven.
Make sure that the fuse is the cause
of the malfunction. If the fuse relea-
ses again and again, contact a
qualified electrician.