Troubleshooting - TEFAL Fast & Delicious Bedienungsanleitung

TROUBLESHOOTING

Problem
Unable to open because
of pressure in the inner
pot.
Pressure in the pot is fully
Unable to open lid.
released but the safety
valve is stuck because it
is too dirty, and therefore
unable to move down.
Sealing gasket is not
properly installed.
The safety valve is stuck
because it is too dirty, and
Unable to close lid.
therefore unable to move
down.
Direction which lid was
closed is incorrect.
Faulty pressure control
Intense release
resulted in release of
of pressure from
pressure.
pressure limit
Pressure limit valve is in an
valve.
incorrect in position.
Food/water ratio is
incorrect.
Food is uncooked
No electricity from the
power supply.
E0 displayed on Lid temperature sensor
digital screen. is faulty.
E1 displayed on The bottom sensor open
digital screen. circuit or short circuit.
E2 displayed on
lid is not locked
digital screen.
E5 displayed on
Abnormal low pressure.
digital screen.
Steam leaking The sealing gasket was
from lid. not properly installed.
Possible reasons Solutions
a.Wait for the pressure in the pot to release
completely.
b. Press and hold the pressure release button.
a. Be sure the pressure is totally released by
leaving to completely cool down for 2 hours
minimum (not under water).
b. Please use a skewer to poke the safety valve,
to make it fall down. Be careful, keep your face
away from the lid and the handle as hot steam/
food may be released.
c. Before next use, please clean and wipe the
safety valve.
Install the sealing gasket properly.
a. Please use a skewer to poke the safety valve,
to make it fall down.
b. Before next use, please clean and wipe the
safety valve (see page 81, cleaning steps of the
safety valve).
Close the lid in the correct direction according
to the instruction manual.
Send it to an approved service center for repair.
Gentling press the pressure limit valve to make
it fall into place.
Use the required food/water ratio
Be sure the releasing valve is not dirty and
creating leakage during cooking.
Check the home electric circuit.
Send it to an approved service center for repair.
Send it to an approved service center for repair.
Check if the program selected requires the lid
totally closed.
If yes, completely lock the lid.
If no, send it to an approved service center for
repair.
Check that gasket is properly installed and
cleaned. Check that pressure limit valve falls
down into place and is cleaned. Check that lid
fixing nut is well tightened.
Remove the gasket, clean it and reinstall the
sealing gasket properly, in correct position (see
page 81, cleaning steps of the lid gasket).
EN
83