Troubleshooting - TEFAL MINUT'COOK Bedienungsanleitung

MULTICOOK_NC00013813_Mise en page 1 16/03/10 16:48 Page9
• Do not replace the power cord with other cords.
• Keep out of the reach of children.
• Do not use the cooking pot on other hobs or in other appliances.
• If pressure is released continuously (for more than 1minute) while pressure cooking, send the
appliance to a service centre for repair.
• Do not fill up the pressure cooker without the cooking pot.
• When opening the lid, always hold the lid by its handle. In some cases, boiling water may be
trapped between the gasket support cover and the lid. This can cause severe scalding.

Troubleshooting

TROUBLE
The appliance beeps and the
display shows .
The appliance automatically
switches to Keep Warm without
going through a complete
cooking cycle.
Lid will not lock.
Cannot open the lid after steam
released.
Air is escaping from the rim of
the lid.
Steam is released from the float
valve.
The float cannot rise.
If you have any problems or queries please contact our Customer Relations Team for expert help
and advice:
Helpline: 0845 602 1454 - UK
01 677 4003 - Ireland
Or consult our web site: www.tefal.co.uk
POSSIBLE REASONS
• The appliance is unable to
build up pressure.
• When there is not enough
water in the cooking pot, the
appliance will switch to Keep
Warm setting.
• The sealing gasket is not
installed properly.
• The float stays up.
• The float is still up.
• No sealing gasket.
• Food stuck in sealing gasket.
• Sealing gasket needs to be
replaced.
• Lid not locked properly.
• Food stuck in the sealing
gasket of the float valve.
• The sealing gasket on the float
is perished.
• The pressure limit valve is not
positioned properly.
• Not enough food and water in
the cooking pot.
• Steam is released from the rim
of the lid and the pressure limit
valve.
SOLUTION
• Check that the lid is closed
properly and that the valve is in
the correct position - fig. 11.
• Add more water in the cooking
pot and restart the cooking
cycle.
• Replace the sealing gasket in
position.
• If this occurs just after cooking,
remove the valve. Then close the
lid and place the valve back into
position. If the product has not
been used and is cold, push the
push rod in directly with your
hands.
• Wait 20 minutes until the
steam is completely released
from the appliance, press the
float valve down with a skewer.
• Install the sealing gasket.
• Clean the sealing gasket.
• Replace the sealing gasket.
• Lock the lid again.
• Clean the sealing gasket.
• Replace the sealing gasket.
• Change the sealing gasket
every two years.
• Check the perfect cleaning of
the sealing gasket.
• Position the valve to
• Put more food and water in the
cooking pot.
• Send the product to our service
centre for repair.
EN
DE
FR
NL
IT
DA
SV
NO
FI
.
9