Programming; Programming Doses - Sanremo F18 Bedienungsanleitung

F18

11 PROGRAMMING

The machine can be programmed on the display
with the Touch function or with the button panel of
groups.

11.1 PROGRAMMING DOSES

A
C
F
The quantity of dispensed coffee can be
programmed for all buttons, except button (E)
which is used for continuous dispensing.
WARNING: when the left
button panel is programmed,
the programmed doses are
automatically transferred to the
EN
other button panels.
The coffee doses can be customised for each
dispensing unit by repeating the operations
performed in the first unit on the left for each unit.
Programming coffee doses
Start the machine as described in the relevant
paragraph.
Program the doses as follows:
- Fit the filter holder with coffee on the left unit of
the machine, as shown in the "OPERATION"
paragraph.
- Position a cup or two cups under the unit
according to the type of programming to be
performed.
- Press button (E) for at least 5 seconds until the
relevant button turns on flashing; the following
message is shown on the display:
PROGRAMMING PRESS THE BUTTON IN 30 sec
B
D
G
E
Programming
- Within 30 seconds, press the dispensing button
to be programmed, for example the button (A)
(single espresso coffee).
While dispensing, the button (A) remains on, the
other button turn off and the button (E) flashes.
- When the coffee reaches the desired quantity in
the cup, press button (A) to stop dispensing; the
quantity of dispensed coffee for that button will
be stored, the button (A) turns off while the other
buttons that still need to be programmed turn on.
- If necessary, repeat the aforementioned
operations to program the other buttons as well;
after 30 seconds without using any button, the
dose programming stage will quit
Programming hot water doses
- Enter the programming function as described
for the coffee, then when button (E) turns on
flashing, press button to start dispensing hot
water; when the desired quantity is reached press
the button again to stop dispensing.
- After 30 seconds without using any button, the
dose programming stage will quit.
11.2 PROGRAMMING ON THE DISPLAY
To access the programming page, press for two
seconds the button
following screens are displayed:
1
2
3
13
102
on the display ; the
12
11
7
4
5
6
8
9
10