Operation; Troubleshooting - Renkforce RF-BTK-200 Bedienungsanleitung

Operation

a) Making a link (pairing)
• Activate Bluetooth on your mobile device.
• Switch the earphones on one of two ways:
- Remove the earphones from the charging case, both earphones will power on and
automatically connect to each other.
- On the left and right headphones, press and hold the multifunction button for 2 seconds.
Both earphones will power on and automatically connect to each other.
• After a short time, RF-BTK-200 appears in the list of available Bluetooth devices on your
device. Select RF-BTK-200.
With some mobile phones it may be necessary after the pairing process to confirm
the link between your mobile phone and the product.
This is normally necessary if you already have at least one other Bluetooth device
registered to the mobile phone or if the mobile phone is connected to another device
(such as a Bluetooth headset).
The link will disconnect if the product or paired Bluetooth device is turned off
or removed from range. When the respective device is turned back on or when
the Bluetooth device comes back into range of the product, the connection is
automatically restored.
The earphones will automatically reconnect to the last paired device each time it is
switched on and within range.
To force reconnect a single earphone (left or right), press the multifunction button. A
tone will sound, and the connection will re-establish after approximately 5 seconds.
b) Switching on and off
• Switch the earphones on one of two ways:
- Remove the earphones from the charging case, both earphones will power on and
automatically connect to each other.
- On the left and right headphones, press and hold the multifunction button for 2 seconds.
Both earphones will power on and automatically connect to each other.
• Switch the earphones off one of two ways:
- Place both earphones in the charging case and close the lid.
- On the left or right headphones, press and hold the multifunction button for 4 seconds. If
one earphone switches off, the other one will switch off automatically.
c) Caller functions
Picking up a call
Press the multifunction button on the left or right earphone
Ending a call
Press and hold the multifunction button on the left or right
Rejecting an incoming call
earphone until a "call rejected" prompt sounds.
Switch call audio between During a call, press and hold the right or left multifunction
smartphone and earphones button until a confirmation tone sounds.
During an incomming call:
• Press the left or right multifunction button once to retain
Three way calling the current call (caller A).
• Double-click the left or right multifunction to switch
between callers (caller A / B)
d) Audio playback
Playback/pause Press the multifunction button on the left or right earphone
Next track Double-click the multifunction button on the right earphone
Previous track Double-click the multifunction button on the left earphone
e) Voice control
To activate voice control, press and hold the multifunction approximately 3 seconds until a
signal sounds.
f) Volume control
• Volume up: Triple click the right earphone multifunction button.
• Volume down: Triple click the left earphone multifunction button.
g) Coupling earphones with each other
The two earphones are already coupled with each other at the factory. If this coupling no longer
exists, proceed as follows:
1. Perform these steps on each earphone separately.
2. Make sure both earphones are switched off.
3. Press and hold the multifunction button until the LED flashes blue.
Care and Cleaning
• Always disconnect the charging station from the power supply before cleaning it.
• Never use aggressive detergents on the earphones and charging station regularly with a
soft brush.
• The earbuds can be removed to clean the earphones.

Troubleshooting

The earphones do not respond to key commands, stop the playback automatically or
cannot be switched on.
• The batteries are flat. Fully charge the batteries.
No sound.
• The volume is set to the minimum.
• The device is no longer paired. Repeat the pairing process.
• The range (max. 10 m) has been exceeded.
There are dropouts in playback.
• The range (max. approx. 10 m) has been exceeded.
• Other devices are interfering with radio transmission. Move away from other wireless devices
or devices that may cause high interference (e.g., powerful electric motors, fluorescent lamps
and microwaves).
Declaration of Conformity (DOC)
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declares that this
product conforms to Directive 2014/53/EU.
Click on the following link to read the full text of the EU Declaration of Conformity:
www.conrad.com/downloads
Enter the product item number in the search box. You can then download the EU
declaration of conformity in the available languages.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Rechargeable batteries ................ LiPo, 3.7 V
Battery capacity ............................ 50 mAh (earphone) / 750 mAh (charging station)
Charging time ............................... 2.5 h (earphone) / 4.5 h (charging station)
Operating time .............................. 3.5 h (talk) / 3 h (music, 80 % volume)
Sound pressure level .................... 110 dB
Bluetooth version .......................... V5.0
Bluetooth profiles .......................... A2DP, HFP, HSP, AVRCP, SPP
Radio frequency ........................... 2402 – 2480 MHz
Transmission power...................... 0 dBm
Frequency range .......................... 20 – 20000 Hz
Operating conditions ..................... 0 to +30 °C, 25 – 60 % RH
Storage conditions ........................ -20 to +60 °C, max. 90 % RH
Cable length ................................. 30 cm
Dimensions (W x H x D) ............... 50 x 31 x 51 mm (charging station)
Weight .......................................... 9 g (earphone pair) / 40 g (charging station)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical state at the time of printing.
Copyright 2020 by Conrad Electronic SE. *1693719_v6_1120_02_dh_m_en