Specifications - Makita 6402 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Low
1-2. High
1-3. Speed control screw
1-4. Switch trigger
1-5. Lock button

SPECIFICATIONS

Capacities
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
For Model DP4700
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Downloaded from www.Manualslib.com
Explanation of general view
2-1. Reversing switch lever
3-1. Reversing switch lever
4-1. Side grip
5-1. Tighten
5-2. Chuck key
Model
Steel
Wood
-1
No load speed (min )
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
Wear ear protection
2
) : 2.5 m/s or less
h,D
2
manuals search engine
6402
10 mm
21 mm
0 - 1,200
264 mm
1.5 kg
ENE032-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG102-3
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG202-3
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Drill
Model No./ Type: DP4700
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
3
6-1. Tighten
6-2. Sleeve
6-3. Ring
DP4700
13 mm
36 mm
0 - 550
275 mm
2.2 kg
/II
Corporation as the responsible
ENG901-1
ENH101-14