When using spraying agents that have been mixed
from herbal preparations, the liquid needs to be
pre-filtered.
For filling the equipment, always use the strainer
inside the filler neck and observe the filler area
through the filling process.
The strainer has a mesh size of 0.55 mm. Only
use original SOLO strainers, part no.: 13279 with
standard mesh size.
Avoid any direct contact of the filling hose and the
contents of the spraying agent tank.
Fill level markings are applied to the backside of
the spraying agent tank .
When filling up the tank, ensure that you do not fill
above the nominal formula (maximum fill volume
Type 452-01 10l,
Never allow the spraying agent tank to overflow or
public bodies of water, rainwater drains or sewage
drains to become contaminated.
Immediately wipe up any spilled spraying agent.
CAUTION:
Never fill different spraying agents into the
spraying agent tank without first thoroughly
cleaning the tank and all parts that come into
contact with the spraying agent and flushing the
system with plenty of clean water.
Recommendation: Use the special SOLO cleaner
for plant protection sprayers (dosing bottle of
500 ml [approx. 16.9 oz], part no.: 49600).
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).
10. Starting / Stopping the engine
Before every use and before every start of the
mistblower check and ensure the machine is in
good and safe condition. (throttle operation,
ignition switch, safety devices, shoulder strap
and check for fuel leaks)
During the starting procedure and while
operating the mistblower, the operator must
have secure footing and have a safe body
position.
The engine starting site should be at least 3
meters away from the refueling site.
Switch ignition switch to "I" position and close
liquid tap. Reset the throttle lever completely.
Type 452-02 13 l).
Filling ; Starting / Stopping the engine
Starting with cold engine
Fig. 6
Close choke with choke lever (10).
Press primer (11) several times until fuel is
visible in the primer.
Place your left hand on the formula tank (Fig. 1
Pos. 1) of the mistblower. Hold the starter handle
(Fig. 1.Pos. 7) with your right hand and pull the
handle up slowly until resistance is felt. Then pull
up firmly and rapidly until the engine 'fires'.
If the engine "tries" to start (ignite), set the
choke in the middle position (partially open)
and if necessary repeat the starting procedure. In
very cold ambient temperature, let the engine with
the choke in the middle position (partially open)
warm up briefly.
As soon as the engine runs smoothly, set
the choke in the open position.
Starting with warm engine after short stop
Start the engine with choke in open position.
Shutting off engine
Reset the throttle lever completely.
After full load running bring the engine to idle for
20sec to cool down.
Move ignition switch to "Stop" position.
ENGLISH 9