Control Panel - Domo DO360A Gebrauchsanleitung

INSTALLATION WALL KIT
The air outlet hose must be used in the "cool" or "auto" mode.
During the "fan" or "dry" mode, you don't need to attache the air
outlet hose.
1. Make an opening in the wall the size of the wall adapter (125
mm).
Insert the wall adapter into the opening and attach it to the
wall using the 4 supplied plugs and screws.
2. Place the hose/appliance connector on one side of the air
outlet hose and the hose/wall adapter connector on the other
side of the hose. The connectors snap into place as soon as
you push them onto the hose.
3. Attach the hose to the unit. The side of the hose with hose/
appliance connector must be mounted on the air outlet at
the back of the appliance. Slide the connector into the air
outlet holders. Make sure that the hook on the connector
matches the notch above the air outlet.
4. Attach the air outlet hose to the wall adapter.
5. When you are not using the air conditioner, you can close the
wall adapter off using the cover.
USE

CONTROL PANEL

7
1. ON/OFF touch
To turn the unit of or on.
2. SLEEP touch
You can use this touch for activating the "sleep"mode.
When pressing the "sleep" touch, the selected temperature will be elevated with 1 °C after 30 min. After
another 30 min the temperature will increase with another 1°C. The airco will maintain this temperature
for 7 hours. After this time, the airco will go back to the original set temperature and the "sleep" function
will end.
NOTE : this function can not be selected with the "fan" or "dry" function.
52
DO360A
6 5
1.
2.
3.
9
8
4
max 120cm
min 30cm
3 2
max 120cm
min 30cm
or
50cm
1