Toshiba MMY-MAP0501T8 Installations-Handbuch Seite 83

7
ADDRESS SETUP
• To change all the indoor addresses from an arbitrary wired remote controller;
(When the setup operation with automatic address has finished, this change is available.)
Contents : Using an arbitrary wired remote controller, the indoor unit address can be changed for each same
refrigerant cycle line
∗ ∗ ∗ ∗ ∗ Change the address in the address check/change mode.
<Procedure> (Operation while air conditioner stops)
1
Push the timer time
Firstly, the line 1, item code
2
Using
3
Push
SET
• The indoor address, which is connected to the refrigerant line of the selected outdoor unit is displayed and the
fan is turned on.
First the current indoor address is displayed on the setup data. (Line address is not displayed.)
4
The indoor address of the setup data moves up/down by the timer time
Change the setup data to a new address.
5
Push
SET
6
Every pushing
sively displayed. Only fan of the selected indoor unit operates.
Repeat the procedure
7
Push
SET
(All the displays on LCD go on.)
8
Push
1
3
Here, if the unit No. is not called up, the outdoor
unit in this line does not exist.
Push button, and then select a line
CL
according to procedure
Downloaded from www.Manualslib.com
+ buttons simultaneously for 4 seconds or more.
AC
(Address Change) is displayed.
+ buttons, select the line address.
UNIT
button.
button to determine the setup data.
button, the indoor unit numbers in the same refrigerant line are succes-
UNIT
4 6
to and change all the indoor addresses so that they are not duplicated.
button.
button to finish the procedure.
CODE No.
SET DATA
UNIT No.
R.C. No.
UNIT
SET CL
Cancel of line selection
2
.
manuals search engine
4
2
8
5, 7
To finish the setup
Operation procedure
1 2 3
19
/ buttons.
CODE No.
SET DATA
UNIT No.
R.C. No.
UNIT
SET CL
4 5 6 7
6
8
End