End Of A Washing / Drying Programme; How To Pause A Programme - Pkm WT 10+6 Bedienungsanleitung

1. Press and hold the button « Temp. » for 3 seconds.
2. The acoustic signal is switched on.
1. Press and hold the button « Temp. » for 3 seconds again.
2. The acoustic signal is switched off.

4.4 End of a washing / drying programme

After a programme is finished, the appliance turns to
automatically. After 10 minutes without using any operating buttons, the
appliance is switched off automatically.
All drying programmes end with a 10-minute cooling down period.
1. After a programme is finished, an acoustic signal sounds if the signal has been
switched on; s. chapter 4.3.3 S
2. The door lock is released after approx. 2 minutes.
3. The operational status indicator of the door lock «
4. Close the water tap.
5. Open the door and remove the laundry.
6. Always turn the rotary knob for the programme selection back to « O
switch off the appliance completely.
7. Leave the door and the detergent dispenser slightly opened, so the moisture can
escape completely.

4.5 How to pause a programme

❖ If you press the button « S
currently running programme is paused.
1. Press and hold the button « S
programme.
2. The programme is paused.
3. Press the button « S
4. The programme starts at the point from where it was paused before.
H
OW TO SWITCH ON THE ACOUSTIC SIGNAL
H
OW TO SWITCH OFF THE ACOUSTIC SIGNAL
ELECTION OF THE ADDITIONAL FUNCTIONS
TART
TART
/ P
TART AUSE
/ P » during a running programme, the
AUSE
/ P » for 3 seconds during the running
AUSE
» again to continue the programme.
~ ~
106
STANDBY MODE
» goes off.
FF
.
» to