Alarm Time Setting; Display Brightness - Bresser MyTime Echo FXR Bedienungsanleitung

according to the indicated polarities (+/–) into
the battery compartment (Fig. 3, 16).
3. Replace the battery compartment cover.
TIME SETTING
1. In normal time mode, hold the TIME key (Fig.
3, 13) for about 3 seconds to switch to time
setting mode. Here you can set the current time
and 12/24 Hr display mode.
2. Press the keys (+) or (–) to set the desired
values and press the TIME key to switch to the
next setting item.
3. Finally, press the TIME key to save the settings
and exit settings mode.

ALARM TIME SETTING

1. In normal time mode, press the ALARM key (Fig.
3, 15) to switch to the alarm time display.
2. While the alarm time is displayed, hold the
ALARM key for about 3 seconds to switch to the
alarm time setting. The hour display flashes.
3. Press the keys (+) or (–) to set the desired hour
10
value.
4. Press the ALARM key. The minute display flashes.
5. Press the keys (+) or (–) to set the desired
minute value.
6. Finally, press the ALARM key to save the
settings and exit settings mode.
ENABLE/DISABLE ALARM
7. After setting the alarm time, move the slider
control (Fig. 3, 10) to 'ON' position to enable the
wake-up call. The alarm symbol (Fig. 2, 3) will
displayed on the LCD.
8. When the alarm sounds at the set alarm time,
press any key to stop the alarm until the same
time the next day.
9. Move the slider control to 'OFF' position to
permanently disable the alarm.

DISPLAY BRIGHTNESS

The following brightness levels can be set for the
LCD: bright, medium, low.