LUCCI Air FUTURA ECO Installationsanleitung Seite 8

Futura Eco Installation Instructions
REMOTE CONTROL
Your ceiling fan is controlled via the remote control. There are 4 buttons (HI, MED, LOW, OFF) to control the fan speed
and one button to control light on/off and dimming function. Fig. 11
Before operating the remote, the following must be considered.
-
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover from the
back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as shown in the battery
compartment. (Batteries not included.)
-
The remote (transmitter) and receiver must be configured so that communication between each other is paired
up. This is achieved by setting the DIP switch on the receiver and remote on the same setting.
Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code
combinations. This is practical when there is more than 1 remote/receiver pair operating locally or in the same
room.
Note: To access the receiver DIP switches, remove the DIP switch cover.
Fig. 9 Remote battery compartment
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and get familiar with the buttons and
function of each button.
LED Indicator
The red LED indicator on the top of the transmitter will flash when the
buttons are active.
BUTTONS ON THE REMOTE
HI: Press the button to set fan running at High speed.
MED: Press the button to set fan running at Medium speed.
LOW: Press the button to set fan running at Low speed.
OFF: Press the button to turn OFF the fan.
: Press the button to turn ON/ OFF the light and press and hold the
button to access the light dimming function.
7 | P a g e
Downloaded from www.Manualslib.com
USING YOUR CEILING FAN
manuals search engine
Fig. 10 Receiver DIP switch
Fig. 11