Star SP200F Serie Bedienungsanleitung Seite 11

Roll paper
Fig. 4-5 Loading the paper
Positioning rib
Paper roll holder
Downloaded from www.Manualslib.com
Core
Paper roll holder
Cover
Roll paper
Fig. 4-6
manuals search engine
2 Cut off the front edge of the roll
paper perpendicularly.
3 Confirm that the power of the printer
is turned on.
4 While observing the direction of the
roll paper, insert the top end of the
paper beneath the paper guide as far as
it will go. If the roll paper is installed,
Axis
the top end of the paper automatically
comes out from the paper exit.
5 Move the paper roll holder in the
direction of the arrow, and insert the
roll so that the holes in the core align
with the axes of the paper roll holder.
Release the paper roll holder to se-
cure the paper.
6 If the paper roll core has not been
properly aligned with the paper roll
holder, the cover cannot to properly
seated until the paper position is
corrected.
7 Press the FEED (paper feed) switch to
feed the paper approximately 10cm.
8 Insert the top edge of the paper into
the tear bar slot, then mount the cover
by reversing the procedure for re-
moving the cover in step 1 above.
Note: When the paper end mark ap-
pears on the paper, replace the
roll paper before it runs out.
Tear bar
FEED switch
– 8 –
Fig. 4-7