Altec Lansing inMotion Air imw725 Bedienungsanleitung Seite 16

Troubleshooting
Symptom Possible Problem
Pairing may have failed.
No sound from
computer with
USB wireless
The USB wireless transmitter may have been plugged
transmitter
into the computer after the music player application
had been launched.
No sound from Pairing may have failed.
the portable
audio device
No sound from Volume on the device is set too low.
the AUX device,
such as an MP3 Source selector is not set to AUX.
player or CD
player connected
to the AUX jack
Sound is distorted Volume level is set too high.
Sound source is distorted.
14
Downloaded from www.Manualslib.com manuals search engine
Solution
If either the "B/T STATUS" LED or the LED on the transmitter – or both – are
solid red, pairing has failed. Try pairing the USB wireless transmitter and the
speaker again.
Close the music player application and relaunch it.
If the "B/T STATUS" LED is solid red, pairing has failed. Try pairing the
Bluetooth-enabled portable audio device and the speaker again.
Increase the volume on the device to approximately ¾ full volume.
Press the "SOURCE/PAIR" button once. The "AUX" LED should light up.
Decrease the volume.
If the original sound source (sound file) is of poor quality, distortion and noise
are easily noticed with high-power speakers. Try a different audio source such
as a music CD.