ROSE DROPPER SEATPOST Bedienungsanleitung Seite 14

3.4 Installing the saddle on the seat post
A
A Loosen the saddle clamp bolts until the bolts still engage in the threads of the nuts by one or two turns. Pull the upper
clamp plate to the top.
B Place one of the saddle rails between the upper and lower clamp plate. Tilt the saddle over the upper clamp plate and
position both saddle rails between the clamp plates.
C Tighten the saddle clamp bolts alternately with a 5 mm hex wrench until you have reached the desired saddle tilt.
Tighten the saddle clamp bolts to a torque of 8 to 10 Nm.
3.5 Routing the cable housing through the frame
1
1. Route the cable housing through the bicycle frame.
→ The cable housing should protrude approx. 5 cm from the seat tube and approx. 40 cm from the head tube.
2. Fit a ferrule (1) to the end of the cable housing protruding from the seat tube.
14
B
C