Cleaning And Maintenance; Transport; Storage; Disposal And Recycling - Scheppach DM500T Original Bedienungsanleitung

Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the designation H05VV-F.
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 230 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm2.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

13. Cleaning and maintenance

Warning! Pull out the mains plug before carrying out
any adjustments, maintenance or repair work!
General maintenance tasks
Wipe swarf and dust off the machine from time to
time with a cloth. Oil the rotating parts once monthly
to extend the life of the tool. Do not oil the motor.
Do not use corrosive agents for cleaning the plastic.
Maintenance
The device has no further internal parts that require
maintenance.
Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Carbon brushes, V-belts
* may not be included in the scope of supply!

14. Transport

If you want to transport the device to a different lo-
cation, disconnect the device from the power supply
and set it down in another appropriate area.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Attention!
Hot surface. There is a risk of burns. Do not trans-
port the machine until the motor unit (22) has cooled
down completely.
Carry the lathe with a second person if possible.
When transporting, hold the lathe by the outer feet
(7), by the rail with the motor unit (3).

15. Storage

Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store the tool in its original packaging.
Cover the tool to protect it from dust or moisture.
Store the operating manual with the tool.

16. Disposal and recycling

The device is supplied in packaging to avoid trans-
port damages. This packaging is raw material and
can thus be used again or can be reintegrated into
the raw material cycle.
The device and its accessories are made of differ-
ent materials, such as metals and plastics. Take de-
fective components to special waste disposal sites.
Check with your specialist dealer or municipal admin-
istration!
Do not throw old equipment away with household
waste!
This symbol indicates that this product must
not be disposed of in household waste as per
Waste Electrical and Electronic Equipment di-
rective (2012/19/EU) and national laws. This
product must be handed over at the intended collec-
tion point. This can be done, for example, by returning
it when purchasing a similar product or delivering it to
an authorised collection point for the recycling of old
electrical and electronic devices. Improper handling
of old devices can have negative effects on the envi-
ronment and on human health due to potential haz-
ardous materials which are often contained in old
electrical and electronic devices. By disposing of this
product properly, you are also contributing to the ef-
fective use of natural resources. Information about
collection points for old devices can be found at your
municipal authority, the local disposal provider, an
authorised location for the disposal of old electrical
and electronic devices or your waste collection ser-
vice.
GB | 27