Moretti Forni F45E Bedienungsanweisung Seite 34

5.4.5 THERMOSTAT REPLACEMENT
After carrying out the operations described in 5.1 above, to replace the
safety thermostat proceed as follows:
- Remove the control panel fixing screws;
- Disconnect the thermostat faston connectors.
- Remove the thermostat dial and bezel (see point 5.4.3);
- Remove the thermostat sensor located inside the compartment;
- Replace the thermostat (item 7 plate B) and the respective sensor;
- Perform the above operations in reverse order to reassemble.
5.4.6. REPLACING THE YELLOW INDICATOR LIGHT AND
THE LIGHT SWITCH
After carrying out the operations described in 5.1 above, to replace the
yellow indicator light and the light switch proceed as follows:
F45/50L
- Remove the control panel fixing screws;
- Disconnect the faston connectors for both the yellow indicator (item
14 plate B) and the light switch (item 4 plate B);
- Replace the yellow indicator light;
- Replace the light switch;
- Perform the above operations in reverse order to reassemble.
F45/50/100L UM
- Open the doors of the leavening compartment;
- Remove the tray rack on the right side;
- Remove the inside upright of the tray rack by unfastening the fixing
screws;
- Disconnect the yellow indicator light fastons (item 3 plate B) and/or
the light switch fastons(item 4 plate B);
- Replace the yellow indicator light and/or the light switch;
- Carry out the steps in reverse order to reassemble.
5.4.7 HEATING ELEMENT REPLACEMENT
After carrying out the operations described in 5.1 above, to replace the
heating elements proceed as follows:
- Open the doors of the leavening compartment;
- Remove the tray racks;
- Remove the protective casings from the heating elements;
- Loosen the screws fastening the heating elements;
- Disconnect the heating element supply wires;
- Remove the heating elements (item 10 plate B);
- Perform the above operations in reverse order to reassemble.
5.5 REPLACING PARTS OF THE LEAVENING CHAMBER
WITH HUMIDIFIER
5.5.1 REPLACING THE TRAY HEATING ELEMENT
After carrying out the operations described in 5.1 above, to replace the
heating element proceed as follows:
- Open the doors of the leavening compartment;
- Remove the tray rack on the right side;
- Unfasten the fixing screws;
- Disconnect the heating element supply wires;
- Remove the heating element (item 19 plate B);
- Perform the above operations in reverse order to reassemble.
5.6 DISPOSAL
When the oven or its spare parts are dismantled, the various components
must be sorted by type of material and disposed of in compliance with
current local laws and regulations.
The presence of a wheeled dustbin with a line
through it indicates that within the European
Union electrical components are subject to special
collection at the end of their working life. As well
as to this device, the standard applies to all of its
accessories
if marked with this symbol. Do not dispose of this
product as normal urban waste.
6 LIST OF SPARE PARTS
Index of plates
Plate A Baking chamber assembly F45E–F50E–F100E
Plate B Leavening compartment assembly F45/50L–
Plate C Wiring diagram F45E
Plate D Wiring diagram F50E-F100E
Plate E Wiring diagram F45E
Plate F Wiring diagram F50E
Plate I Wiring diagram F45/50L–F45/50/100L UM
Plate L Hood extraction kit wiring diagram F45/50/100K
INSTRUCTIONS FOR ORDERING SPARE PARTS
Orders for spare parts must contain the following information:
- Appliance type
- serial number
- Name of part
- Quantity required
UK/14