Making The Electrical Connection To The Product - Bosch Rexroth LU 2 Montageanleitung

38/54 Assembly
Bosch Rexroth AG, MIT: LU 2, 3 842 358 814/2018-12

8.6 Making the electrical connection to the product

High electrical voltage!
Risk of serious injury or death from electric shock.

Make sure the relevant system component is not under pressure or voltage
before electrically connecting the product.

Secure the system against being unintentionally switched on again.
Damage to the product caused by faulty electrical connection
The product can be damaged.

Electrical connection requires basic mechanical and electrical knowledge.

The product should only be started up by qualifi ed personnel (see page 9).

The voltage supply must comply with the connection data of the lubrication unit
(see "Technical data" on page 52
• Choose the control and sensor elements in accordance with EN ISO 13849.
• Comply with VDE regulation 0100 for Germany, or corresponding regulations in the
country of use.
2
1
358 814-10
Fig. 17: Plug assignment (view of the drive socket)
Table 10: Plug assignment
Pin Cable color Signal
1 brown Voltage supply + V DC
2 white Signal output
3 blue Voltage supply GND
4 black Signal output Err
Signal states for the outputs OK and Err see Table 8 on page 26.
WARNING
NOTICE
4
3