Safety Instructions; Technical Data - Desoutter CVI3 Schnellstartanleitung

English
Original instructions.
© Copyright 2020, Ets Georges Renault 44818
St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is intended to be used to drive,
monitor and control the Desoutter range of tools.
No other use permitted.
For professional use only.
EMC restriction of use: for industrial use only.

SAFETY INSTRUCTIONS

Class A digital device
NOTE: This equipment has been tested
and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
Any changes or modifications to this equipment
not expressly approved by Ets Georges Renault
may cause harmful interference and void the
FCC authorization to operate this equipment.
General instructions
Warning
Risk of electric shock
To reduce risk of injury, everyone
using, installing, repairing, maintaining,
changing accessories on, or working
near this tool must read and understand
the safety instructions before performing
any such task. Failure to follow all
instructions listed below may result
in electric shock, fire and/or serious
personal injury.
06/2020
Warning
Risk of explosion if a battery pack is
replaced by an incorrect type. Dispose
of used batteries packs according to the
instruction.
Electrical safety
Warning
This controller must be earthed.
The controllers must be plugged into an outlet
properly installed and grounded in accordance
with all relevant codes and ordinances.
● Never remove the grounding prong or modify
the plug in any way.
● Do not use any adaptor plugs.
● Check with a qualified electrician if you are
in doubt as to whether the outlet is properly
grounded.
Differential circuit breaker
The controller has a thermal protection and
a protection by means of over current and
differential circuit breaker.
The controller is equipped with a differential
circuit breaker to protect the operator from
electric shock.
● Never replace the circuit breaker by a
model of higher value.
● Never replace the circuit breaker by
short-circuit.

TECHNICAL DATA

● See page 5.
Additional data
Normal environmental conditions (for IEC 61010-
1 standard)
Operating temperature
Maximum relative
humidity
Category equipment
Altitude up to
Usable in Pollution
degree 2 environment
Line voltage
Alternating current.
The controllers can support 100-240 V~
single phase but the system is properly
working at 100-120V or 200-240V~.
21 / 144
6159932290_13
5°C to 40°C
41°F to 104°F
80% for temperatures
up to 31°C
II
2,000 m
indoor use only