Electrical Safety; Personal Safety - Scheppach multi cut 5 Originalbetriebsanleitung

ELECTRICAL SAFETY

details on the machine's rating plate.
example pipes, radiators, stoves, refrigerators,
etc. to prevent receiving an electric shock.
the cable out of the socket using the plug.
Always protect the cable from oil, heat and
sharp edges. Damaged cables can cause an
electric shock.
mains cable for signs of damage.
the main switch is not locked in its on position.
have been specifically approved for this purpo-
se.
to prevent the cable from overheating. Min. wire
cross-section 1.5 mm2.
with a residual current-operated circuit-breaker
(RCCB).
are making adjustments.
away from the tool.

PERSONAL SAFETY

that you wear non-slip shoes.
may become caught in moving parts.
instruction will reduce the risk of serious inju-
ries.
Following this instruction will reduce the risk of
serious injuries.
16
instruction will reduce the risk of serious inju-
ries.
ne.
is defective. An electric tool that cannot be
switched on or off is dangerous and must be
repaired.
contact with the material.
switch on the machine.
reduce the load on the machine or switch it off.
Using suitable electric tools you can work more
safely and better within the specified capacity
range.
with the machine, for example using a clamp or
a vice. Do not machine any workpieces that are
too small to secure. If you hold the workpiece
with your hand, you will not be able to operate
the tool safely.
CAREFUL HANDLING AND USE OF ELECTRIC
TOOLS
you to work better and more safely with them.
ded by the manufacturer.
which may contain electric cables, gas or water
pipes. Use suitable detection equipment to loca-
te these cables and pipes.
the maximum cutting depth of the cutting disc.
without loading the machine.
reach a standstill before you put it down.
-
-