Gesipa TAURUS 1 Betriebsanleitung Mit Ersatzteilliste Seite 23

Unscrew oil top-up tank from the riveting tool and
wipe up any escaped hydraulic oil with a cloth.
Screw in oil filler plug (J) with gasket (K) with
TORX screwdriver T20.
®
Carefully unscrew oil filler plug (J) by approx. 2
turns; the piston unit will slowly move into the
forward end position. Collect any leaking oil with
a cloth.
Screw on steel head sleeve (B)
Regular maintenance will extend the service life of your high-quality GESIPA
and they should be serviced at least every 2 years by an authorised workshop or by
GESIPA Service. We recommend servicing tools that are subject to intensive use
®
ahead of schedule.
9.4 Storage
The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
10. Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the as-
sembly and setting procedures and operation by non-skilled personnel may result in serious
damage to the blind rivet setting tool. In case of doubt, always send the blind rivet setting tool
back to the supplier or to GESIPA
Screw on the oil top-up tank provided with cover.
Gradually increase the air pressure to mains
pressure at the regulator; any excess hydraulic oil
will be squeezed out.
Unscrew oil top-up tank from the riveting tool and
wipe up any escaped hydraulic oil with a cloth.
Screw in oil filler plug (J) with gasket (K) with
TORX
Carefully unscrew oil filler plug (J) by approx. 2
turns; the piston unit
will slowly move into the forward end position.
Collect any leaking oil with a cloth.
Screw on steel head sleeve (B)
.
®
screwdriver T20.
®
GB
tools
®
23