Connecting The Adsl2+ Wlan Modem Router - Hama 00053120 Bedienungsanleitung

g Operating Instruction
Package contents:
1x Hama ADSL2+ Wireless LAN Modem Router, 54 Mbps
1x 12 V power supply unit
1x Printed operating instructions
1x RJ45 network cable
1x RJ11 DSL connecting cable
1x Voucher Kaspersky Internet Security (90 days version)
System requirements:
• Computer with built-in network card or WLAN adapter
• Operating system with TCP/IP protocol installed
• Java-capable Web browser such as Mozilla Firefox, Microsoft Internet Explorer or Opera.
Safety notes:
Do not use the device in moist or extremely dusty areas, on radiators or near heat sources. This device is not designed for use out-
doors. Protect the device from pressure and impact. The device may not be opened or moved during operation. Do not use the device
without an antenna attached.
Warning: Use the router with the enclosed power supply unit only. Using other power supply units can cause irreparable damage to
the product.
Note: !! The "Connect On-Demand" setting is recommended if you have a pay-as-you-go payment plan (if you pay according to volu-
me or time). This means that the Internet connection is disconnected automatically after the period set in the "Idle" fi eld (see section
6.4). Connection costs may be high if you are permanently connected to the Internet. Please also note that closing the browser does
not automatically disconnect you from the Internet. A number of programs send requests to the Internet or receive data without this
being clearly indicated. For the router, these requests are just as valid as opening a browser, for example. If you want to ensure that
there is no active connection to the Internet, you should switch off the device.
Requirements for installing the HAMA ADSL2+ WLAN Modem Router, 54 Mbps:
Ensure that you have the following before installing the Hama ADSL2+ WLAN Modem Router:
1. Enabled ADSL or ADSL2+ connection
2. Installed DSL splitter provided by your DSL connection service provider
3. User information from your Internet provider
4. Computer with installed (and error-free) network card
1

Connecting the ADSL2+ WLAN Modem Router

Connect the computers and other network devices such as hubs/switches to ports 1-4. Use a crossover or CAT5 patch cable (max.
100 m). The integrated switch automatically detects the connection speed of 10 or 100 Mbps, half/full duplex transfer mode and the
type of cable used.
Connect the DSL splitter to the "ADSL" connection on the rear of the ADSL2+ WLAN modem router using the DSL connecting cable.
Plug the provided power supply unit into an empty socket and connect it to the router.
Caution: Unsuitable power supply units can cause damage.
Checking the installation:
There are different LEDs for indicating the status on the top of the device:
LED
POWER
WLAN-G
SYNC
LAN 1-4
Downloaded from www.Manualslib.com
State Status
Illuminated Power supply unit is connected and supplying power
Off No power unit connected, device not being supplied with power
Flashing Wireless LAN is activated/data is being sent
Off Wireless LAN is deactivated
Illuminated Modem has successfully synchronised with the switching centre
Flashing Modem is attempting to synchronise with the switching centre
Illuminated The corresponding LAN port has established a correct network connection
Flashing Data transfer via respective LAN port
Off No connection
manuals search engine
23