Oakley JUDGE II DUAL TIME Bedienungsanleitung Seite 5

2 JUDGE II DUAL TIME INSTRUCTION MANUAL
®
SETTING THE DATE AND TIME: MAIN DIAL FACE
To set the date and time the first time (or to reset the date and time after the battery is replaced), do the fol-
lowing. Before you begin, ensure that the secondary crown (located at the 4 o'clock position) is pushed fully
down against the case.
TO SET THE DATE AND TIME:
1. Pull the main crown out to the first click position (a).
2. Slowly turn the main crown until yesterday's date
appears.
Do not turn the crown too rapidly. Doing so can lead
to a false date indication. If this occurs, slowly turn
the crown until the date display goes from 01 to 31,
then continue until yesterday's date appears.
3. Pull the main crown out to the second click position
(b).
4. Turn the hands forward until today's date appears,
then continue forward until the current time is
reached. If the current time is in the afternoon or
evening, move the hour hand all the way around the
dial to pass 12 o'clock noon.
5. Push the main crown back in.
To set the exact second, wait until the second-
counting hand reaches the zero position before you
pull out the main crown to the second click position
(b). Set the time, then wait until the exact second
is reached before pushing the main crown back in.
To adjust the time and date for subsequent settings,
use these short procedures:
TO SET THE TIME
1. Pull the main crown out to the second click position
(b).
2. Turn the main crown until you reach the correct
time.
3. Push the main crown back in.
Downloaded from www.Manualslib.com manuals search engine
TO SET THE DATE
1. Pull the main crown out to the first click position
(a).
2. Slowly turn the main crown until you reach the
correct date.
If the current time is between 9:30 PM and 3:00
AM, set the date to the following day. (This is
necessary to ensure the date display will normally
change at midnight instead of 12 noon.)
3. Push the main crown back in.
Crown
Pos A Pos B