PEERLESS Mounts SUF650P Montageanleitung Seite 7

For Flat Back Screen
Begin with the shortest length screw, hand thread through washer and adapter bracket into screen as shown below.
2-1
Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten. If screw
cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack. Repeat for
remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
NOTE: If screen manufacturer's requirements state that more than 0.33" of ventilation is required, spacers may be
used to add an additional 0.5" of space between the wall and the screen as shown right.
SCREEN
For Bump-out or Recessed Back Screen
Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into screen
2-2
as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
Downloaded from www.Manualslib.com
WASHER (I)
ADAPTER
BRACKET (B)
If you have any questions, please call Peerless customer care at 1-800-865-2112.
SCREEN
SPACER (J)
If you have any questions, please call Peerless customer care at 1-800-865-2112.
manuals search engine
SCREW
WASHER (I)
ADAPTER
BRACKET (B)
7 of 34
SCREEN
SPACER (J)
ADAPTER
BRACKET (B)
SCREW
ISSUED: 05-29-08 SHEET #: 202-9282-5 12-01-09
WASHER (I)
SCREW