Operation - IBIZA LIGHT PAR LED CAN Handbuch

1. BEFORE YOU BEGIN
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are
present and have been received in good condition. Notify immediately your dealer and retain packing material for
inspection if any parts appear to be damaged from shipping or the carton itself shows signs of mishandling. Keep the
carton and all packing materials. In the event that a fixture must be returned for repair, it is important that the
fixture be returned in the original box and packing.
Safety Instructions
Please read these instructions carefully, they include important information about the installation, usage and
maintenance of this product.
• Please keep this User Guide for future reference. If you sell the unit to another user, be sure that he also receives
this instruction booklet.
• Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is
not higher than that stated on the bottom of the fixture.
• This product is intended for indoor use only!
• To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no flammable
materials close to the unit while operating.
• The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent surfaces. Be
sure that no ventilation slots are blocked.
• Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse size
and type.
• Maximum ambient temperature (Ta) is 104° F (40°C). Do not operate the fixture at temperatures higher than this.
• In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest
authorized technical assistance center. Always use the same type of spare parts.
• Don't connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on.

OPERATION

Prior to using the unit for the first time, plug the supplied mains adaptor into a suitable mains outlet and into the DC
socket on the unit. Let the built-in Lithium battery charge for about 8 hours. Unplug the mains adaptor from the
mains outlet and the unit. Press the black button on the unit to switch it on or off.
SETTINGS
©Copyright LOTRONIC 2015
GB
•
Press the MENU button until the desired mode is displayed.
•
Change the setting via the UP & DOWN buttons
• Confirm the setting via the ENTER button.
Page 2