Installing the LCD Monitor to
the Wall
Using the optional Wall-Mount Bracket
(SU-WL850, SU-WL500 or SU-WL450)* (not
supplied)
To Customers:
For product protection and safety reasons, Sony
strongly recommends that installation of your
LCD Monitor be performed by Sony dealers or
licensed contractors. Do not attempt to install it
yourself.
To Sony Dealers and Contractors:
Provide full attention to safety during the
installation, periodic maintenance and
examination of this product.
Wall-Mount Bracket Installation Information
This LCD Monitor's instruction manual only
provides the steps to prepare the LCD Monitor
for Wall-Mount installation before it is installed
on the wall. For instructions on Wall-Mount
Bracket installation, see the Installation
Information (Wall-Mount Bracket) on the
product page for your LCD Monitor model.
https://www.sony.eu/support
Preparing for Wall-Mount Installation
Make sure to attach the Table-Top Stand before
installing the LCD Monitor to the wall by
referring to the Setup Guide.
• Prepare the LCD Monitor for the Wall-Mount
Bracket before making cable connections.
• Follow the instruction guide provided with the
Wall-Mount Bracket for your model. Sufficient
expertise is required in installing this LCD
Monitor, especially to determine the strength
of the wall for withstanding the LCD Monitor's
weight.
• Be sure to entrust the attachment of this
product to the wall to Sony dealers or licensed
contractors and pay adequate attention to
safety during the installation. Sony is not liable
for any damage or injury caused by
mishandling or improper installation.
• The screws for Wall-Mount Bracket are not
supplied.
• Only qualified service personnel should carry
out wall-mount installations.
• For safety reasons, it is strongly recommended
that you use Sony accessories, including:
Wall-Mount Bracket SU-WL850
Wall-Mount Bracket SU-WL500
Wall-Mount Bracket SU-WL450
• Be sure to use the screws supplied with the
Wall-Mount Bracket when attaching the
Wall-Mount Bracket to the LCD Monitor. The
supplied screws are designed as indicated by
illustration when measured from the attaching
surface of the Wall-Mount Bracket.
The diameter and length of the screws differ
depending on the Wall-Mount Bracket model.
Use of screws other than those supplied may
result in internal damage to the LCD Monitor
or cause it to fall, etc.
10 mm – 12 mm
Screw (M6)
Wall-Mount Bracket
VS
• Be sure to store the unused screws and
Table-Top Stand in a safe place until you are
ready to attach the Table-Top Stand. Keep the
screws away from small children.
* Only on limited region/country/LCD Monitor model.
1
Remove the screws from the rear of the
LCD Monitor.
GB
13
GB