BRAYER BR1090 Bedienungsanleitung Seite 9

- control the tray (1) filling with water drops; when
the tray (1) is filled up, remove it, drain water and
install the tray (1) back to its place;
- if you have not used the thermopot for a long time,
the water dispense may malfunction. In this case it
is recommended to open and close the lid (9) and
to switch the water dispense on again.
• To switch the thermopot off press and hold the button
(12) «Start/re-boil» for 5 seconds, take the plug of the
power cord (8) out of the mains socket.
• Remove the lid (9) (pic. 1) and allow complete
cooling-down of the thermopot.
• Tilt the thermopot and drain the remaining water,
install the lid (9) back to its place and press the lock
button (10) (pic. 1).
USAGE OF THERMOPOT
• Prepare the thermopot for operation, as specified in
the previous section (fill with water, insert the power
plug into the mains socket).
• Water heating up and keep warm modes selection
• Press the button (12) «Start/re-boil» on the control
panel (5), the indicator of the button (12) «Start/re-
boil» will light up, the symbol (27) «
symbol (18) « » will light up, water will start heating
up, the water temperature is shown with digital
symbols (19).
• After water boiling the symbol (27) «
flashing for 60 seconds, then it will go out, you will
hear sound signals, the indicator of the button (12)
«Start/re-boil» will go out as well, the thermopot will
switch on in the keep warm mode, the hot water
keeping temperature «85°C» is set by default.
• In the hot water keeping warm mode you can set the
hot water keeping temperature for various beverages
by pressing the button (13) «Temperature selection»,
the respective symbols (18) light up:
- « » - water boiling mode, water is heated up to
the boil and digital symbols (19) «100°C» are
shown.
- « » - hot water keeping mode up to «95°C»
for black tea brewing, the temperature «95°C»
is set by default. To change the water heating up
temperature use the buttons (24) «- ... +», the
range of temperature selection is from 87°C to
95°C.
- « » - hot water keeping mode up to «85°C»
for coffee brewing, the temperature «85°C» is
set by default. To change the water heating up
temperature use the buttons (24) «-/+», the range
of temperature selection is from 80°C to 86°C.
- « » - hot water keeping mode up to «65°C» for
» and the
making herbal tea, the temperature «65°C» is
set by default. To change the water heating up
temperature use the buttons (24) «-/+», the range
of temperature selection is from 65°C to 79°C.
» will be
EN 9