Cleaning And Maintenance - BRAYER BR1090 Bedienungsanleitung

keeping warm mode for coffee brewing, the symbol
(18) « » and digital symbols (20) «85°C» will light
up.
• Where it is necessary to re-boil water, press the
button (12) «Start/re-boil» on the control panel (5),
the indicator of the button (12) «Start/re-boil» will light
up, the symbol (27) «
» will light up, water will start heating up, the water
temperature is shown with digital symbols (19). After
water boiling the symbol (27) «
for 60 seconds, then it will go out, you will hear sound
signals, the indicator of the button (12) «Start/re-boil»
will go out as well, the thermopot will switch on in the
keep warm mode, the hot water keeping temperature
«85°C» is set by default.
• To switch the thermopot off press and hold the button
(12) «Start/re-boil» for 5 seconds, take the plug of the
power cord (8) out of the mains socket.
Child lock
• Use this function to protect children from hot water
burns.
• To switch the child lock on, press and hold the
«Lock» button (15) for 5 seconds, the indicator of
the buttons (14) «Water dispense» and «Lock» will
light up.
• The button (14) «Water dispense» on the control
panel (5) is inactive in the child lock condition.
» and the symbol (18) «
» will be flashing
• To switch the child lock off press and hold the button
(15) «Lock» for 1 seconds, the indicators of the
buttons (14) «Water dispense» and (15) «Lock» will
light out.
• To switch the thermopot off press and hold the button
(12) «Start/re-boil» for 5 seconds, unplug the unit.

CLEANING AND MAINTENANCE

• Before cleaning the thermopot unplug (8) it, remove
the lid (9) and allow complete cooling-down of the
thermopot. (pic. 1)
• Always drain the remaining water from the thermopot
flask, to do this remove the lid (9).
• Carefully tilt the thermopot to drain the remaining
water.
• Remove the tray (1), remove the grid (2), pour the
water out of the tray (1), wash the tray (1) and the
grid (2). Place the grid (2) on the tray (1) and place
the tray (1) on its installation place.
• Clean the outer surface of the thermopot body (7)
with a slightly damp cloth and then wipe it dry.
• Use neutral detergents to remove dirt, do not use
metal brushes, abrasives and solvents.
• Do not immerse the thermopot and the power cord
(20) into water or other liquids.
• Do not put the thermopot in a dishwashing machine.
Stains on the inner surface of the thermopot flask
• Water contains various minerals that can cause
stains on the inner surface of the thermopot flask, the
EN 11