Tig Welding - Jackle JESS WELDING inoMIG 350 Betriebsanleitung

inoMIG 350/400/500
7.3

TIG welding

Fig. 12
Connect the TIG welding torch/hose torch
A
Ground socket
B Electrode socket
C Gas
D Start
E Gas outlet
K
7.3.1 TIG intermediate cable assembly (option)
Fig. 13
7.3.2 TIG welding torch cable assembly
Connect the welding torch to the ground socket, remote control socket, water connections, and gas outlet.
Please observe the colours of the water connections. The wire feed unit with control lead must remain
plugged into the machine.
7.3.3 Potentiometer for welding current control
In order to regulate the strength of the welding current in TIG operating mode, the potentiometer must be
connected to the 17-pole remote control socket as shown in the circuit diagram. In MIG mode, you must also
call the remote control function via Fx and, for EC1, you must set the "Curr – CAn" parameter.
7.3.4 Starting the welding process
Set the control box to TIG operating mode, set the parameters for the welding tasks, and press the torch
trigger to start the welding process.
BA-0014 • 2020-06-05
F
17-pole remote control socket
G Data cable to wire feed unit
H + socket
I Water return "red-hot"
J Water flow "blue-cold"
K Water
Intermediate cable assembly option, item 802.015.215
7-pole torch
7 Putting into operation
A
B
C
D
E
F
G
H
I
J
17-pole machine
EN - 17