Permanently Unpairing A Device - Silvercrest SBKL 5.0 A1 Bedienungsanleitung Und Sicherheitshinweise

2. Pair your smartphone or audio or media player to the headphones via
Bluetooth®. Follow the operating instructions for your smartphone or
media player (the Bluetooth® function must always be activated on the
smartphone or media player). From the list of devices found, select the
device "SBKL 5.0 A1" on your smartphone or media player and
establish the connection.
A beep sounds to indicate pairing has been successful. The LED
indicator (5) flashes briefly every three seconds.
If you switch your headphones off or take them out of range, the
headphones switch themselves off after a few minutes and the LED
indicator (5) goes out.
As soon as the previously paired device comes back into the range of the
headphones, the connection is established automatically. You may need to
confirm the connection on your smartphone or media player.
If you wish to pair another device (smartphone or media player) to the
headphones, proceed as described under "Permanently unpairing a
device" below.

9.2.1 Permanently unpairing a device

If necessary, you can permanently unpair you smartphone or media
player. This prevents a connection being established when both devices
are switched on an in range. At the same time, you can establish a new
pairing with a new device.
1. Switch your headphones and the smartphone or media player on. After
a few seconds, a connection should be established between the
devices.
2. Press and hold the Bluetooth® button (4) for at least 2 seconds until the
LED indicator (5) starts flashing quickly in blue. The existing pairing is
SilverCrest SBKL 5.0 A1
English - 43