Using The Vacuum Cleaning Robot; Starting/Stopping Cleaning - Samsung SR8950 Benutzerhandbuch

USING THE VACUUM CLEANING ROBOT

Starting/Stopping Cleaning

You can run or stop all vacuum cleaning robot functions.
■
Each vacuum cleaning robot function only runs when the
Power Switch is turned on.
■
When the vacuum cleaning robot is operating, press the (
button to cancel the operation and select a function.
Turning the power on or off
Turning the power on
- Main unit: Press the (
Turning the power off
- Remote control: Press the
- Main unit: Press and hold the (
❈
If no key is pressed for approximately 1 minute after turning the power
on, the power is automatically cut to prevent the battery discharging.
To turn the power on again, press and hold the power (Start/Stop)
button on the main body.
Starting or stopping cleaning
Starting
- Remote control : Press the Auto, Spot, Max, Manual button.
- Main unit : Select Auto, Spot, Max mode by using the (
and then pressing the (
- When cleaning begins, the vacuum cleaning robot starts to move.
❈
Pressing the (
to perform the Auto mode cleaning.
Stopping
- To stop, press the (
- When cleaning is stopped, the vacuum cleaning robot stops.
) button.
[Power] button.
) button down for 3 seconds.
) button.
) button without selecting cleaning mode starts
) remote control or main unit button.
)
Using the remote Using the remote
control control
) button
Using the main unit Using the main unit
buttons buttons
operating _27