Daily Use - Electrolux GA55GLI220 Benutzerinformation

60 www.electrolux.com
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser

7. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
A B
A
+ -
C
D
1.
Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3.
Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between po-
sition 1 (lowest quantity) and posi-
tion 4 (highest quantity).
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the Multitab option.
5. Set and start the correct programme
for the type of load and the degree of
soil.